Scanmaster not working with 2.2 chip

Discussion in 'Scanmaster 2.1 for Buick (box style)' started by Chengleng Cha, Aug 20, 2019.

  1. Chengleng Cha

    Chengleng Cha New Member

    I finish installing my powerlogger and replaced the chip in my scanmaster. Scanmaster data wire connected to powerlogger connection unit per instruction. When I key on, the scanmaster doesn't display 2.2 and PL from I read on the forums. The scanmaster always display 888 888 numbers. I tired reinstalling the chip multiple times with no success and inspected to make sure no bent pins during install. If i reinstall the old chip, the scanmaster will display 2.1. I have reflash the powerlogger with the software found on here and made sure scanmaster g is not selected in the option. I could be missing something so any help would be appreciated.
     
  2. EricM

    EricM Administrator Staff Member

    Maybe something is wrong with the 2.2 chip. If you can send it back to me, I'll check it out.
     
  3. Chengleng Cha

    Chengleng Cha New Member

    I also believe something wrong with the chip too. I will send the chip to you. Thank you eric.
     
  4. Chengleng Cha

    Chengleng Cha New Member

    Hi eric. Did you find anything wrong with the chip?
     
  5. EricM

    EricM Administrator Staff Member

    Yes it was bad, so I'm in the process of making another one. It may go out today or tomorrow.
     
  6. Chengleng Cha

    Chengleng Cha New Member

    I install the new chip and everything is working. Thank You for your help for Eric.
     

Share This Page