Chip Instructions for the 6.0 and 6.1 wideband Chip

Discussion in 'Downloads and Chip Instructions' started by EricM, Nov 30, 2008.

  1. EricM

    EricM Administrator Staff Member

    Last edited: Nov 26, 2013
  2. JW87T

    JW87T Well-Known Member

    Eric,
    I notice that the 6.0 instructions now state the default values for the AF values as 'Varies'.

    Why is that? Does it vary with the type of WBo2? The original instructions I got said the AF defaults were 10.8/10.8/11.5 for
    1-2/3-4/mid-boost. Is that correct for my setup with PLX wb?

    Thanks.
    ..Jack W.
     
  3. EricM

    EricM Administrator Staff Member

    Some people asked for different default settings, some also default to off (9.9). Whatever yours is when you reset the ECM is the default. I didn't want to make difference instructions for each chip, so I changed it to "varies" in the instructions. I should probably say "varies by chip".
     
  4. JW87T

    JW87T Well-Known Member

    OK, thanks. I am guessing my chip's defaults are the ones you originally documented since I haven't changed them.

    One more question: there was a thread with a question about how much people have to increase fueling because of cold weather. With the 6.0, do you even have to worry about that? Cold air means more air going in which should cause the 6.0 chip to increase fueling to compensate to maintain the target AFR, right?

    ...Jack.
     
  5. EricM

    EricM Administrator Staff Member

    Yep, it will add fuel on its own to maintain the target air/fuel ratio.
     
  6. EricM

    EricM Administrator Staff Member

    Updated the instructions to clarify some things. (same link from the 1st post)

    Eric
     
  7. MNwe4

    MNwe4 Well-Known Member

    6.0 updates?

    Eric, just browsing the forums. Does the 6.1 WB update also include the closed loop idle option like the 5.7 update? Keep up the good work!
     
    Last edited: Jul 5, 2011
  8. EricM

    EricM Administrator Staff Member

    No it doesn't have that feature. Not enough room in there!
     
  9. MNwe4

    MNwe4 Well-Known Member

    Ah, I got ya. Looking forward to getting the 6.1 in the near future. Thanks.
     
  10. chargedtt

    chargedtt New Member

    What the difference between the 6.0 chip and the 6.1 chip?
     
  11. EricM

    EricM Administrator Staff Member

    If you click the Home button at the top to see the home page, there is an explanation there.
     
  12. buddiiee

    buddiiee Member

    On this wideband tracking chip, can you set one up for the LC2?
     
  13. EricM

    EricM Administrator Staff Member

    Yes, all the Innovate widebands have the same output signal.
     

Share This Page